Gas Fired Thermal Oil Heaters

Introduction of Gas Fired Thermal Oil Heaters

Gas fired thermal oil heaters have a three-pass round coil structure. A conical coil is used for the effective protection of the furnace wall at the boiler end. This product is equipped with an advanced combustion device and is fully automated in operation. After the burner ignites the fuel, flame fills the round coil tubes and transfers heat by radiation through the tube wall (first pass). The high temperature flue gas gathers at the back door and then turns to the convection tubes section (second pass), where heat transfer takes place by convection. The flue gas gradually cools down here and flows to the front door, where it is reversed and goes into the third pass. After that, it enters into the chimney through the economizer and is released into the atmosphere.

Technical Advantages of Gas Fired Thermal Oil Heaters

Digitized manufacture

The laying-off of steel tube adopts CNC 3D laser cutting machine.

The manufacture of square coil tube adopts CNC three-dimensional tube bending machine, no forced shaping.

The manufacture of serpentuator adopts serpentuator automatic production line, once-forming.

Full argon arc welding

Square coil tube and coil tube all adopt argon arc welding technique,which guarantees tubes are 100% qualified.

Long life span

The optimized radiation heating surface and convective heating surface, the medium flow is more reasonable, without overheat of the carrier and reduce the life.

Set up effective flue gas partition for convection heating surface and cast partition to make it works longer.

Easy operation

We have combustion arch patent, which is available for different types of coals, even the anthracite is very easy to burn.

Flame-proof feeding bucket can avoid the feeding bucket is burnt and coking.

There is ash cleaning unit, which is easy for maintaining, operating and cleaning.

Less fuel consumption

Use superior refractory brick to build inside and superior perlite in the middle. Keep the furnace temperature under 50℃ to make the minimization of loss.

The key processes including material cutting, rolling, drilling are done by advanced CNC machining process to reduce the assembly stress and extend boiler service lifetime.

Furnace adopts double close line coil, which makes heating surface sufficient.

Hot Products

Best High Efficiency Gas Boiler
Best High Efficiency Gas Boiler

Best high efficiency gas boiler is designed with longitudinal double drums and " D " type chamber structure. The furnace is on the right and convection tube bank is on the left.

1-20 t/h More
High Efficiency Gas Boiler
High Efficiency Gas Boiler

High efficiency gas boiler is a boiler shell type 3 passes wetback gas fired boiler. After fuel is being atomized by burner, flame is full of the wave furnace and transfer heat via furnace wall...

10-100 t/h More
Energy Efficient Gas Boilers
Energy Efficient Gas Boilers

Energy efficient gas boilers is designed with longitudinal double drums and " D " type chamber structure. Furnace is placed on the right and convection tube bank is on the left...

0.7-14 MW More

Get A QUOTE FOR FREE

Please fill out the form below, leave your contact number, common email address, equipment usage and other information, and describe the product requirements as much as possible. We will quickly process the information you submitted to ensure that your purchase consultation receives timely and accurate response.